ROBOT Millennium v. 19.0 Maintenance Pack 7

Robot Millennium 19.0.7

• Removal of the error in the ”autosave” function (error made in MP6),
  With the Autosave option active, if the “Save” (“Save As”) command was not called up after calculations, then first activation of autosave resulted in ascribing a zero value to calculation results.

Others:

• Possibility to load projects saved in the STAAD format in which UK sections are used.
• A tolerance value determined during generation of a model by adjusting it to the value defined by the user (it used to be twice as great).
• Enabled saving of maps (isolines) for bottom result envelopes in a dxf/dwg format.

Steel element design:
General:

• Improvement of the functionality of the dialog box for manual check of the buckling length.

BS 5950:2000 code:

• Possibility to deactivate the buckling analysis.
• Correction of calculations of wall slenderness for a box section defined by the user.
• Correction of calculations of flexural-torsional buckling in the case of a cantilever.

PN code:

• Correction of calculations of beams made of an I-section with different flanges.

Verification of steel connections:

• Correction of recognition of a pinned support when a connection type is selected automatically.

RC Design:

• Spread footing reinforcement:
  • correction of reinforcement generation for spread footings with two columns,
  • conditions for taking account of the minimum reinforcement applied for the top reinforcement of a spread footing.